Zanussi ZC 605 M 매뉴얼 - 페이지 5

{카테고리_이름} Zanussi ZC 605 M에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZC 605 M 18 페이지. Electrogas cooker

페이지 인쇄

INSTRUCTIONS FOR THE USER

INSTALLATION

It is important that all operations are carried out by

qualified personnel, in the normal manner.

The specific instructions are describred in the chapter

on installation.

Before using the unit, take off the special protective

layer which protects the stainless steel and anodyne

tin parts.

USE

Control knobs on the cooker

The knobs for using the gas cooker are found on the

control panel.

The regulation knobs should be turned in anti-

clockwise direction until the small flame symbol, and

vice-versa for the larger symbol.

No gas supply

Maximum gas supply

Minimum gas supply

POTTERY

Remember that a wide-bottomed pan allows a faster

cooking than a narrow one.

Always use pots which properly fit what you have to

cook.

Particularly make sure that the pans are not too small

for liquids, since these could easily overflow.

Moreover, the pans should not be too large for a faster

cooking. In fact, grease and juices may spread on the

bottom and burn easily.

It is better to use non-openable moulds for baking

cakes. In fact, an openable mould lets juices and sugar

leak through, falling on the bottom of the oven and

consequently burning on the bottom of the baking tray,

making cleaning difficult.

Avoid putting plastic-handled pans in the oven as they

are not heat-proof.

You should use oans with the right diameter to fit the

burner, in order to make the most out of it, thus

reducing gas consumption as in Fig. 2.

It is also advisable to cover any boiling casserole and,

as soon as the liquid starts boiling, lower the flame

enough to keep the boiling point.

IGNITION OF HOB BURNERS

To ignite a burner, before positioning the saucepan,

use the appropriate switch marked by a small spark,

push the corresponding knob in completely and turn in

an anticlockwise direction to the maximum position;

upon ignition regulate the flame as required.

In models provided with a safety device, the control

knob must be pressed in for approximately 5 seconds

until the safety valve automatically keeps the flame lit.

If after a few attempts the burner does not ignite, check

that the baffle and its cap are correctly positioned.

To interrupt the supply of gas, turn the knob in a

clockwise direction to the position " ".

During cooking, when using fats or oils, take

particular care as they can, when over-heated, self-

ignite.

Fig. 2