Zanussi ZCG662 사용자 설명서 - 페이지 8

{카테고리_이름} Zanussi ZCG662에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZCG662 24 페이지. Cooker
Zanussi ZCG662에 대해서도 마찬가지입니다: 사용자 설명서 (28 페이지)

Zanussi ZCG662 사용자 설명서

Hob - Daily use

Warning! Refer to the Safety chapters.
Lighting the burners
Warning! Be very careful when you use
open fire in a kitchen environment. The
manufacturer declines all responsibility in case
of misuse of the flame.
Always light the burner before you put
cookware on it.
1. Turn the knob to the maximum position
and push it down. When you push the
knob, the spark generator activates auto-
matically.
2. Keep the control knob pushed for approxi-
mately 5 seconds. This lets the thermo-
couple warm up. If not, the gas supply is
interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are in
the correct positions.
9
8
7
6
8
Burner cap
1
Burner crown
2
Ignition candle
3
Thermocouple
4
Hob
5
Slots
6
Burner body
7
Location peg
8
Hole
9
Replacing burner parts
1. Carefully put the burner crown on the
burner body. Do not use force.
a) Make sure that the hole in the crown
b) Make sure that the location pegs are
c) Let the crown fall freely onto the body.
d) Make sure that you can move the
2. Put the burner cap centrally on top of the
1
crown (enamel side up). Move the cap
from side to side and front to back to make
2
sure that it is correctly installed.
3. Try to light the burner. If the burner does
3
not ignite, adjust the crown and cap again.
4
Warning! Do not keep control knob
5
pressed for more than 15 seconds.
If the burner does not light after 15 seconds,
release the control knob, turn it into off position
and wait for at least 1 minute before trying to
light the burner again.
If the burner accidentally goes out, turn
the control knob to the off position and try
to light the burner again after minimum 1 mi-
nute.
The spark generator can start automatical-
ly when you switch on the mains, after in-
stallation or a power cut. It is normal.
is above the ignition candle.
in the slots in the burner body.
crown a small distance from side to
side.
www.zanussi.com