Directed DIRECTECHS HK14 설치 매뉴얼 - 페이지 4

{카테고리_이름} Directed DIRECTECHS HK14에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed DIRECTECHS HK14 19 페이지.

Introduction

The HK14 firmware for Directed Digital Solutions is compatible with specific Hyundai vehicles. It is a complete

solution for remote start, security (if applicable), bypass interface, and convenience. This guide provides

information on the installation of the module using HK14. If you would prefer using this system as a digital

solution, go to www.directechs.com and search for the make, model and year of the vehicle. This will allow

you to find the proper firmware and corresponding installation guide.

Warning! This module can only be programmed via the web tool, which can be found on www.directechs.com or using the

Directechs Mobile application for mobile devices. Features and functions will become accessible when you connect the module

using the XKLoader.

Firmware notes: This section highlights important information for this specific firmware and will assist in

pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.

T-Harness

compatible

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic

connector.

Refer to the "Vehicle wiring reference chart" following each installation type.

General notes: This section highlights important information for this specific firmware.

The siren is ONLY required when enabling the security features during module flashing.

[1]

The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin.

[2]

The Green wire is ONLY required for starter disable and antigrind applications.

[3]

The K-Line connection is NOT required in US vehicles without transponder.

[4]

ONLY required to retain OEM remote functionality during remote start runtime.

[5]

Additional parts required (maximum required):

6A Diode

0 x 1A Diodes

87a

0 x Relay

Keys required for

programming

Resistor 100Ω

0 x Resistor

Keys required for

operation

Fuse 7.5A

0 x Fuse

Directed Digital Solutions HK14