Clarke PED14A50 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke PED14A50에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke PED14A50 17 페이지. 3hp direct drive compressor

OPERATION

1. Insert the mains plug into the mains socket and switch on the power.

• The mains voltage must be 230V.

2. Lift the red On/Off switch.

• The compressor will make a

continuous loud noise when the

tank is charging - this is normal.

• The compressor will charge the

main tank to 8 bar (116 psi) then

switch off.

• The compressor will restart

automatically whenever the

pressure in the main tank falls

below a certain level.

3. Check the safety valve daily by

pulling on the ring attached.

• Air should be released you pull

the ring and stop when

released.

• If the valve does not operate as

described, or if the valve is

stuck, it must be replaced by

qualified service personnel

before using the compressor.

WARNING: DO NOT REMOVE OR ATTEMPT TO ADJUST THE SAFETY VALVE.

4. Select the pressure you need using

the pressure regulator. (if fitted)