Directed 322VTT 설치 매뉴얼 - 페이지 11
{카테고리_이름} Directed 322VTT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed 322VTT 18 페이지. Recreational vehicle security system
페이지 인쇄5.
Ignition. Release the Valet®/program switch. Turn the vehicle key to the "OFF" position.
The siren will give a long chirp. The programming mode has been exited.
6.
Once the programming is done. "Green H 1/5" remove the Green wire from the ground.
7.
Try. Use the arm/disarm button of each transmitter to verify that the security system
operate properly.
To exit the transmitter learn routine, do one of the following:
■ Turn the vehicle key to the "OFF" position.
■ More than 15 seconds elapses between steps.
■ Valet®/Program switch is pressed too many times.
Transmitter learn routine
To program 470 transmitter to the main control unit:
1.
Green H 1/5 wire will need to be connected to ground for the learn routine to work.
2.
Ignition. Turn the vehicle key to the "ON" or "RUN" position.
3.
Choose. Press two times on the Valet®/program push switch and hold it the second time.
The siren will chirp one time.
4.
Transmit. While holding the Valet/program switch push in, press on the
the first transmitter (a long chirp will be heard). Press on the
transmitter (a long chirp will be heard).
5.
Choose. Press two times on the Valet®/program push switch and hold it on the second
time. The siren will chirp two times.
© 2005 Directed Electronics, Inc. (Canada)
(470T)
button of
button of the second
11