Califone Music Maker 2395IR 소유자 매뉴얼 - 페이지 13
{카테고리_이름} Califone Music Maker 2395IR에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Califone Music Maker 2395IR 17 페이지. Infrared music maker plus, 2395ir infrared music maker plus, 2395irplc-6 six-person learning center (shown above)
Califone Music Maker 2395IR에 대해서도 마찬가지입니다: 제품 카탈로그 (8 페이지)
Other Features and Functions
Extension Speaker Jacks
Stereo extension speakers may be plugged into the 1/4" L (left) and R (right) speaker jacks (28) on the rear of the cabinet.
NOTE: WHEN EXTENSION SPEAKERS ARE PLUGGED IN THE INTERNAL SPEAKERS ARE DISABLED
Microphone Jack
To record using a dynamic microphone, plug into the 3.5 mm jack (29) on the rear of the cabinet. Another jack, 2.5 mm (30) is provided
for use with Califone model 4805AV microphone with remote Start/Stop.
RC-2300 Remote Control
• The RC 2300 provides most functions available on the Music Maker™ controls. It does not, however, function with tape operations.
• INTRO : One feature added to the remote is the Intro function. While in the CD mode press the 'PLAY' button, then press the
'INTRO' button. This will give a preview of each track for 10 seconds. Press the INTRO button again to resume normal play. If
the INTRO button is not pushed a second time, the preview will continue through the last track. Pushing PLAY, PAUSE or STOP
will not disengage the Intro function.
• MUTE : Mute is another feature added to the remote. It works with tape, AM/FM and CD functions.
• 10+ : This button allows you to jump forward a number of tracks rather than use the scan forward feature. From stop, pause
or play, pushing the 10+ button once will show a 1 and a flashing – (dash) see 1-. To jump to track 15 enter 5. To go to track
23 from track 6 press 10+ twice and see 2-. Enter 3 and jump to track 23.
Other Notes
- The 'SCAN/SKIP' buttons are the same as the Tuner p, 'Skip forward|' and Tuner q, Skip back |' buttons on the boombox.
- The 'REPEAT' button is the same as the 'PRESET/REPEAT' button on the boombox.
- The 'TIME' button is the same as the 'PLAY TIME' button on the boombox.
Care and Handling of Compact Discs
1. Handle the disc by its edges or center hole. To keep the disc clean, avoid touching the data surface.
2. Data is embedded directly beneath the label, protected only by a thin lacquer layer and is more vulnerable to damage than
the bottom. A scratch that penetrates the label will certainly destroy data, whereas a scratch on the bottom can often be
overlooked or corrected by the laser pickup.
3. Do not write on the label surface. A ballpoint will damage data; marking pens have solvents that may penetrate the top layer.
4. Do not stick paper or tape on the label surface; this probably won't hurt the disc but might jam the disc drive.
5. Do not expose a disc to high temperature or humidity for an extended period of time. The disc material will soften at around 200
degrees Fahrenheit. Allow the disc to reach room temperature before playing if it has been subjected to extreme cold.
6. Preventive cleaning is unnecessary and potentially harmful. Clean only when required.
7. Clean a disc with a soft moistened cloth. Pat dry. Wipe the disc from the center out like spokes of a wheel. Never wipe across
a disc as you would an LP record.
8. Never use solvents, commercial cleaners or sprays designed for LP's. Plain lukewarm water is recommended.
9. Keep discs protected at all times.
Care and Maintenance
12
continued page 13