Clarke Raider 55 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke Raider 55에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Raider 55 17 페이지. 3hp direct drive compressor

OPERATION

1. Insert the mains plug into the mains socket and switch on the power.

• The mains voltage must be 230V.

2. Lift the red On/Off switch.

• The compressor will make a

continuous loud noise when the

tank is charging - this is normal.

• The compressor will charge the

main tank to 8 bar (116 psi) then

switch off.

• The compressor will restart

automatically whenever the

pressure in the main tank falls

below a certain level.

3. Check the safety valve daily by

pulling on the ring attached.

• Air should be released you pull

the ring and stop when

released.

• If the valve does not operate as

described, or if the valve is

stuck, it must be replaced by

qualified service personnel

before using the compressor.

WARNING: DO NOT REMOVE OR ATTEMPT TO ADJUST THE SAFETY VALVE.

4. Select the pressure you need using

the pressure regulator. (if fitted)