Clarke RANGER 30 air 운영 및 유지 관리 지침 - 페이지 4
{카테고리_이름} Clarke RANGER 30 air에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke RANGER 30 air 8 페이지.
페이지 인쇄
SAFETY PRECAUTIONS
WARNING
As with all machinery, there are certain hazards involved with their operation
and use. Exercising respect and caution will considerably lessen the risk of
personal injury. However, if normal safety precautions are overlooked, or
ignored, personal injury to the operator, or damage to property may result.
It is in your own interest to read and pay attention to the following rules:
NEVER direct a jet of air at people or animals, and NEVER discharge
compressed air against the skin. COMPRESSED AIR IS DANGEROUS,
NEVER operate your compressor with any guards removed.
NEVER carry out electrical or mechanical repairs unless you are fully qualified.
If problems occur, contact your Clarke dealer.
NEVER exert any strain on electrical cables and ensure that air hoses are not
tangled or wrapped around machinery etc.
NEVER T leave pressure in the receiver overnight, or when transporting.
NEVER adjust, or tamper with the safety valves. The maximum pressure is
factory set, and clearly marked on the machine.
NEVER operate in wet or damp conditions. Keep the machine dry at all
times. Similarly, a clean atmosphere will ensure efficient operation. Do not use
in dusty or otherwise dirty locations.
Some of the metal parts can become quite hot during operation. NEVER touch
these until the machine has cooled down.
ALWAYS adjust the pressure regulator to the recommended setting for the
particular spray gun or tool being used.
ALWAYS ensure that there is adequate ventilation and keep clear of any possible
source of ignition when spraying inflammable materials e.g. cellulose paint.
ALWAYS protect yourself. Think carefully about any potential hazards which
may be created by using the air compressor and use the appropriate
protection. e.g. Goggles will protect your eyes from flying particles. Face masks
will protect you against paint spray and/or fumes.
ALWAYS consult paint manufacturers instructions for safety and usage before
spraying any material always .
ALWAYS ensure the pressure is expelled from the air receiver, and the machine
is disconnected from the mains supply Before carrying out any maintenance.
ALWAYS ensure that the air supply is turned off at the machine outlet when
disconnecting air hoses or other equipment from your compressor. Expel all
pressurised air from within the machine and other equipment attached to it.
ALWAYS ensure that children and animals are kept well away from the
compressor and any equipment attached to it.
ALWAYS ensure that all individuals using the compressor have read and fully
understand the Operating Instructions supplied.
ALWAYS ensure that any equipment or tool used in conjunction with your
compressor, has a safety working pressure exceeding that of the machine.
4
RANGER 60
No. Description
Qty Part No.
50 Reservoir
1
FN17005400V
51 End Plug
2
FN011008000
52 Drain valve
1
FN022020000
53 Wheel
2
FN020001000
54 Push on Fasteners
2
FN015029000
56 Hand Grip
1
FN020121000
58 Rubber Foot
1
FN020093000
59 Valve Assembly
1
FN347043000
60 Valve
1
FN047113001
61 Spring
1
FN047113002
62 Washer
1
FN010041000
64 Valve
1
FN347027000
65 Adapter
1
FN199110140
66 Pressure Gauge-Res 1
FN330007000
No. Description
Qty Part No.
67 Adapter
1
FN011017000
68 Pressure Gauge-Line 1
FN330006000
69 Tube
-
FN046001000
70 Elbow
1
FN011002000
71 Anti-vibration pads
1
FN199575000
72 Steel Tube
4
FN170HN0010
73 Adapter
1
FN011248000
74 Screw
4
FN014013042
75 Regulator Assy w/filter1
FN319042000
76 Pressure Reg. Assy
1
FN321028000
77 Mains Lead w/plug
1
N101GA0200
78 Tap Assy
1
FN322008000
79 Quick Release Conn. 1
FN116011065
13