Clarke REBEL 30 운영 및 유지 관리 지침 - 페이지 5

{카테고리_이름} Clarke REBEL 30에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke REBEL 30 14 페이지.

PREPARATION FOR USE

NOTE: All numbered items throughout this manual refer to the parts list item number

on Pages 12 to 15.

Remove the plastic travel plug from the oil filler hole, on the

top of the crank case, and insert the dipstick (see Fig. 6 - p.9).

Check the oil level is at the correct level on the dipstick, as

shown in Fig.1. Where necessary, top up with Clarke SAE40

Compressor Oil (available from your Clarke dealer).

NOTE: if you intend using your compressor for spraying, read also the "Helpful

Hints on Spraying" booklet - supplied with the machine.

Check that the mains voltage corresponds with that shown on the data sticker

on the crankcase cover of the machine.

Ensure that the ON/OFF knob is in the 'OFF' (0) position, i.e. pushed DOWN,

then plug in and switch on at the mains supply.

To start the compressor pull UP the ON/OFF knob to the 'ON' (I) position

- the motor should start immediately.

(Ref. Fig. 2)

Fig.1

Fig. 2

Illustration is of

Rebel 30.

Component

layout for the

Rebel 60 is the

same,

although some

components

differ slightly in

appearance