Clarke SE36 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke SE36에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke SE36 17 페이지. Air compressor electric motor driven

BEFORE STARTING COMPRESSOR, CHECK:-

1. Compressor Pump Oil Level using (a) Dipstick (to level

marked) or (b) sight glass (see fig.1)

2. Automatic Control:- Pressure switch ON/OFF switch is in

the OFF position.

WARNING:

1. BEFORE STARTING COMPRESSOR, OPEN ALL OUTLET VALVES.

2. THE FOLLOWING START AND STOP INSTRUCTIONS MUST BE

FOLLOWED IN THE CORRECT SEQUENCE TO AVOID SERIOUS

DAMAGE TO THE COMPRESSOR/MOTOR.

TO START COMPRESSOR

1. Switch on isolator (mains supply)

2. Switch on pressure switch (lift knob or twist switch). (See "GENERAL

ARRANGEMENT" on page 8., item 22)

3. Check rotation (Flywheel/Fan blows air over pump)

4. Run compressor for 10 minutes with outlet valves open (first time of

operation only).

5. Close valves and check that pressure does not exceed maximum working

pressure (stamped on machine plate), if the pressure exceeds the

maximum working pressure stated, stop the machine (see below), vent the

system and contact the Clarke Service Department.

1. Switch off at the pressure switch (Push knob down or turn switch).

2. Isolate from the Mains Supply.

3. Drain air receiver (release drain tap).

WARNING: COMPRESSOR PUMPS, DELIVERY PIPES WILL REMAIN HOT FOR

SOME TIME AFTER USE.

NOTE: When starting compressors up to and including the 3HP models,

an auto bleed valve will operate and air will be heard vent. This is

quite normal and should not cause concern. The valve should

close after several seconds. Should it fail to close, consult your

Clarke dealer.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]