Clarke SHHH 10 운영 및 유지 관리 지침 - 페이지 8

{카테고리_이름} Clarke SHHH 10에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke SHHH 10 11 페이지. Shhh air compressor

SHUTTING DOWN THE COMPRESSOR

To shut down the compressor, simply turn the ON/OFF switch to the 'O' (OFF) position.

ALWAYS switch the compressor ON or OFF at the Pressure Switch...NEVER at the mains

Close the air outlet tap and trigger the equipment (spray

gun,air tool etc.) to release air from the air hose before

disconnecting the hose from the machine.

Before transporting your compressor or when leaving

overnight, expel all air from the receiver by opening the

drain valve - Fig 5.

DO NOT FORGET to close the valve again when the tank is empty, particularly if the

compressor may not be used for some time.

DAILY

1. Check the oil level before you start and top up if necessary - use Synthetic

Air Compressor Oil ONLY, available from your Clarke dealer..Part No. 3050795

The oil level is checked by viewing the oil sight glass, see Fig. 1.

To add oil, proceed as follows:

Remove the air breather (see Fig.7), and top up

until the oil level is midway on the oil sight glass.

2. Drain any condensate that may have

accumulated in the air outlet filter, by pushing

the valve (arrowed in Fig. 6), upwards, with

the tank under pressure.

3. When you have finished with the compressor,

ALWAYS open the drain valve to expel all air,

and to allow any condensate to drain off.

DO NOT FORGET to close the valve again

when the tank is empty.

NOTE: In order to drain condensate by opening

the drain valve, the tank MUST be under pressure.

IMPORTANT:

supply switch

Fig.5

IMPORTANT:

Fig.6