Clarke SHHH 2/10 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke SHHH 2/10에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke SHHH 2/10 11 페이지. Shhh air compressor

PARTS IDENTIFICATION

Fig.1

The compressor MUST be filled with oil before use.

A 500mL bottle of Synthetic Oil is provided.

Remove the travel plug, fitted to the Oil Filler/

Breather, and fill with oil using the funnel provided,

so that the level is midway across the Oil Sight Glass

(indicated in Fig.1).

When satisfied, place the breather, contained in

the bag of loose parts, firmly on to the Filler/Breather

spout.

Firstly, ensure the compressor is on level ground...do not allow it

to run if it is standing on an incline.

Check also that the mains voltage corresponds with that

shown on the data label on the side of the compressor.

Ensure that the ON/OFF switch, mounted on the Pressure

Regulator (shown in fig. 3), is turned to the '0' (OFF) position,

then plug in and switch ON at the mains supply.

To start the compressor, turn the ON/OFF switch to the

'I' (ON) position - the motor should start immediately.

NOTE: Should the motor fail to start immediately, it is possible

that the air receiver is already full of air. Check the tank

pressure gauge (see fig. 4). If you release air, by opening

the air drain valve (see fig. 1), the motor will start

automatically once the cut-in pressure is reached.

Fig.2

Fig.3