Alecto SA-300 매뉴얼 - 페이지 12
{카테고리_이름} Alecto SA-300에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alecto SA-300 19 페이지. Smoke detector for domestic use
Alecto SA-300에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 매뉴얼 (10 페이지)
페이지 인쇄
INSTALLATION INFORMATION:
Attach the ceiling plate using the included plugs and screws to the ceiling on a location
of choice. Wall mounting is not recommended for smoke detection. Then put the de-
tector to the ceiling plate and, twist clockwise to lock it in place. It will emit a beep and
be ready for use. Perform a first test by holding the key for three seconds. Also see the
paragraph: "Testing".
Ceiling
USING, TESTING AND MAINTENANCE:
Using:
The smoke detector works if the smoke detector has been mounted to the ceiling.
A red LED will light up and the smoke detector will beep briefly to let you know that it
has been activated, because the ceiling plate has switched a lever on the inside.
The red LED will now flash every 40 seconds. Once smoke is detected, the alarm will
sound. Once the smoke disappears, the smoke alarm will stop automatically.
Test:
Hold the button for at least 3 seconds. The operation is still correct if you hear 2 or
three signal tones. Check the smoke detectors weekly. In alarm status the smoke de-
tector will generate about 85dB(A). Do not use candles, open fire or cigarettes to test
the smoke detector.
Time-out function:
This function will deactivate the alarm for about 5 minutes. This function can be
enabled by pushing the HUSH/TEST button very shortly. The LED will now blink once
every 8 seconds to indicate the deactivated smoke alarm.
After 5 minutes, the alarm will be fully active once again. If there is (still) any smoke in
the environment, the alarm will go off again.
This function can be used repeatedly.