Clarke WARRIOR 60 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} Clarke WARRIOR 60에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke WARRIOR 60 8 페이지.

페이지 인쇄

1. Maintenance

PREPARATION

FOR USE

NOTE: All numbered items throughout this manual refer to the parts list item number

on Pages 12 - 15

Remove the plastic travel plug from the oil filler hole,

on the top of the crank case, and insert the dipstick

(see Fig. 7 - page 9).

Check the oil level is at the correct level on the

dipstick, as shown in Fig.1. Where necessary, top up

with Clarke Compressor Oil (Available from

your local Clarke dealer).

OPERATION

(Ref. Fig. 2)

NOTE: If you intend using your compressor for spraying, read also the 'Helpful

Hints on Spraying" booklet - supplied with the machine.

Check that the mains voltage corresponds with that shown on the data sticker

on the crankcase cover of the machine.

Ensure that the ON/OFF switch is in the 'OFF' (0) position, i.e. pushed DOWN,

then plug in and switch on at the mains supply.

To start the compressor pull UP the ON/OFF switch to the 'ON' (I) position

- the motor should start immediately.

Fig.1

Fig. 2

Illustration is of

Warrior 30.

Component

layout for the

Warrior 60. is

the same,

although some

components

differ slightly in

appearance

SPECIFICATIONS

Rotational Speed .................................................. 2850 rpm

Max. Pressure Warrior 30 & 60 ........................... 10 bar

Warrior 30 110V .......................... 8 bar

Air Displacement .................................................. 8.7 cu ft/min (247L/min)

Electric Motor ........................................................ 2 hp (1.5kW)

Receiver

Warrior 30 .................................... 24 LTR

Warrior 60 .................................... 50 LTR

Fuse Rating ..... Warrior 30 & 60 ........................... 13amps

Warrior 30 110V .......................... 20Amps

Duty Cycle ............................................................ S1 at max. 7 bar

(i.e. Compressor may run continuously at 7 bar max.)

Please note that the details and specifications contained herein, are correct at the time of going to

print. However, CLARKE INTERNATIONAL reserve the right to change specifications at any time without

prior notice. Always consult the machines Data Plate

ACCESSORIES

Your Warrior Air Compressor can be used in conjunction with a range of optional

accessories for inflating tyres, air brushing, stapling, blowing and many other uses.

For details contact your local Clarke dealer.

Air kits are available which are ideal for almost all applications (see below).

Kit illustrated is KIT 1000 - Part No. 3110155

Also available without the spray Gun Kit 600 - Part No. 3110150

- or items sold separately

Should you experience any difficulties obtaining accessories, please contact

Clarke International sales department by telephoning 01992 565300 for details of

your nearest dealer.