Clarke WIZ - MINI 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke WIZ - MINI에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke WIZ - MINI 8 페이지.

OPERATION

NOTE: This machine is designed for use with air bushes or other devices that

require a low volume, low pressure air supply.

Check that the mains voltage corresponds with that shown on the data

label on the crankcase cover of the machine.

Ensure that the ON/OFF switch (see fig. 1) is in the 'OFF' (O) position. Attach

the air hose to the outlet on the handle, using either the 1/8"BSP thread, the

1/8" BSP adapter. Attach the air tool.

To start the compressor, plug in and switch on at the mains supply then switch

the motor switch to the 'ON' (I) position - the motor should start immediately.

If it does not.. .refer to 'Fault Finding' on p.7.

SHUTTING DOWN THE COMPRESSOR

To shut off the compressor, simply switch the ON/OFF switch to the OFF (O)

position. Always use this switch to shut down the compressor. NEVER USE THE

MAINS SWITCH TO STOP MOTOR.

Trigger the equipment (spray gun, air tool etc.) to release air from the air

hose before disconnecting the hose from the machine.

NEVER UNSCREW A CONNECTION WHILST THE AIR LINE IS UNDER PRESSURE.

ALWAYS MAKE CERTAIN THAT THE AIR TOOL HAS BEEN TRIGGERED

After the first 5 hours of running the compressor, check the cylinder head

screws and retighten - equally to 10 lbs ft. if any have worked loose.

Every 50 hours (more frequently if

used in a dusty environment), clean

the air intake filter, by unscrewing

the two screws securing the plastic

end cover prising off the cover then

removing the two screws securing

the air filter.

The filter may be gently washed in

warm soapy water rinsed and

allowed to dry thoroughly before

refitting. It should be renewed if

badly soiled or contaminated with

paint, and if it has been washed

two or three times.

WARNING!