Clarke XPPV11/50 운영 및 유지보수 지침 매뉴얼 - 페이지 13
{카테고리_이름} Clarke XPPV11/50에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke XPPV11/50 17 페이지. Xppv11 series; xpp15 series; 50l engine driven air compressor
페이지 인쇄
SYMPTOM
Compressor
constantly 'on
load' and
cannot attain
the working
pressure
required.
Unusual noise
from
compressor.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PROBABLE CAUSE
Suction filter blocked.
Leak between compressor
block and air receiver leaks in
or near air receiver.
Valves blocked by dirt, paint,
dust or choked up.
Inspection cover or drain plug
leaking.
Pressure gauge defective
Unit too small in relation to air
consumption.
Compressor worn.
Bolts loose.
Flywheel loose.
Unit installed on an unsuitable
base.
Bearings, piston rings or
cylinder worn.
Valve broken
REMEDY
Clean / Change filter.
Tighten connection and
repair leak.
Contact Clarke Service
Department
Empty air receiver and
change seals/plugs.
Change pressure gauge.
Use a larger capacity
compressor
Have compressor
overhauled or replace it.
Tighten bolts
Tighten flywheel
Move unit to a more solid
base
Contact Clarke Service
Department
Contact Clarke Service
Department
13