Directed XpressKit DBALL 매뉴얼 - 페이지 11
{카테고리_이름} Directed XpressKit DBALL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed XpressKit DBALL 19 페이지. Ford5 remote start ready (rsr) installation
Directed XpressKit DBALL에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지)
페이지 인쇄
Platform: DBALL/DBALL2
Firmware: FORD5 Remote Start Ready (RSR) Installation
Press the PTS button to turn the ignition OFF.
4
The LED flashes green then, turns on solid orange
after 10 seconds.
Press the PTS button to turn the ignition ON.
5
The LED starts flashing orange slowly.
6
Disconnect the module and complete the Key2GO programming.
Web Programming (for Key2GO)
Refer to the LED Diagnostics section for more information and for troubleshooting purposes.
Version 4.5 or higher of XpressVIP must be installed on your computer to complete this programming sequence.
Remove the module from the vehicle and reconnect it to your computer. The Directechs web site will
1
automatically recognize that you are moving onto the second phase of the programming sequence.
2
Click on Submit Key2GO Request.
Once the configuration is completed, r econnect the module.
3
The LED turns ON solid green for 3 seconds, then turns off.
4
You may now reinstall the key fob battery.
You have successfully completed the module programming sequence.
&
ENGINE
PUSH 1X
START
STOP
Flashes
Green
ENGINE
PUSH 1X
START
STOP
Solid x3 Secs
© 2016 Directed. All rights reserved.
Rev.: 20160317
Page 11
&
Solid
Orange
&
Flashes Orange
slowly
&
Off
Remove
Battery