Directed XpressKit DBALL 매뉴얼 - 페이지 3
{카테고리_이름} Directed XpressKit DBALL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed XpressKit DBALL 19 페이지. Ford5 remote start ready (rsr) installation
Directed XpressKit DBALL에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지)
Platform: DBALL/DBALL2
Firmware: FORD5 Remote Start Ready (RSR) Installation
Installation Diagram Type 1
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
Refer to the Vehicle Wiring Reference Chart for more information on specific wiring and connections.
6 Amp
diodes
86
(+) 12V
87a
Fuse 15A
14014 Link Connector
(behind glove compartment)
HS CAN Low:
White, pin 1
9
21
1
10
22
11
23
2
HS CAN High:
12
24
3
White/Blue,
13
25
4
pin 2
14
26
15
27
5
16
28
6
17
29
7
18
30
19
31
8
20
32
C2280C (BCM)
20
40
19
39
18
38
17
37
16
36
15
35
14
34
13
33
12
32
11
31
10
30
9
29
8
28
(+) PTS:
7
27
Red, pin 28
6
26
5
25
4
24
3
23
2
22
1
21
Not required in D2D mode.
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
C2280A (BCM)
(+) Parking Light: Yellow/Blue, pin 1
(+) Parking Light: Brown/Yellow, pin 26
85
87
30
MS CAN Low:
Violet/Orange, pin 40
MS CAN High:
Gray/Orange,
pin 41
33
34
35
36
37
38
39
40
MS CAN High: Tan/Black: 3
MS CAN Low: Tan: 4
HS CAN High: Orange/Green: 5
HS CAN Low: Orange/Brown: 6
(+) 12V
(-) Ground
(-) Parking Light: Red/Black: 4
(+) Push-To-Start Output: Gray/Black: 7
Data TX: Yellow/Black: 10
60
59
58
Data RX: Orange/Black: 11
57
TX:
56
Yellow/Orange,
55
pin 54
54
53
RX:
52
Violet/Gray,
51
pin 34
50
49
48
47
46
45
44
43
42
41
22
1
23
2
24
3
25
4
26
5
27
6
28
7
29
8
30
9
31
10
32
11
33
12
34
13
35
14
36
15
37
16
38
17
39
18
40
19
41
20
42
21
(+)12V: Red: 13
Ground: Black: 14
RF
Prog. Button
LED
Rev.: 20160317
BCM (passenger side, behind glove box)
The Remote Start
Safety Override Switch
MUST be in the OFF
position.
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood
DBALL/
DBALL2
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2016 Directed. All rights reserved.
Page 3