Directed Xpresskit DBALL2 설치 매뉴얼 - 페이지 9

{카테고리_이름} Directed Xpresskit DBALL2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Xpresskit DBALL2 19 페이지. Ford5 remote start ready (rsr) installation
Directed Xpresskit DBALL2에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (18 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (15 페이지), 설치 및 빠른 참조 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지)

Platform: DBALL2

Firmware: CHRYSLER7 Remote Start Ready Installation (RSR)

Press on the Start/Stop button (PTS) twice

to turn the ignition ON. The LED flashes orange slowly.

Press on the Start/Stop button (PTS) once

to turn the ignition OFF.

Disconnect the module and complete the Key2GO procedure (see below).

Web Programming (for Key2GO)

Refer to the LED Diagnostics section for more information and for troubleshooting purposes.

Version 4.5 or higher of XpressVIP must be installed on your computer to complete this programming sequence.

Remove the DBALL from the vehicle and reconnect it to your computer. The Directechs web site will

automatically recognize that you are moving onto the second phase of the programming sequence.

Click on Submit Key2GO Request.

Once the configuration is completed, r econnect the module.

The LED turns solid green with a quick orange flash.

You have successfully completed the module programming sequence.

Rev.: 20160610

Page 9

to ON

ENGINE

(RUN)

START

STOP

PUSH x2

Flashes

Slowly

PUSH x1

ENGINE

START

STOP

to OFF

Solid Green &

Quick Orange