Platform: DBALL2
Firmware:
NISS06
Remote Start Ready
Module Programming
Refer to the
LED
Diagnostics section on page
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Note: Before connecting either the
function programming is selected using Xpress
version of the application.
Warning!
To take advantage of advanced features, you must use Xpress
available functions and features.
1. Connect the interface module to your computer using the
2. Open an Internet Explorer browser (version 6 or higher), and go to www.directechs.com. The detail of the platform and firmware
that is currently saved on the interface module will be indicated in the top
3. Select the
year make
,
and
4 In the search result page, select
.
5. Once you have configured your options, click on the
6. The following message will be displayed when the upload is completed:
"The flashing is successfully completed. You may now unplug the kit."
You can now proceed with the programming instructions below.
SmartStart Installation
The
DBALL
module
must
be connected to it. Failing to do so could damage
a.
To
ensure that the D2D communication between SmartStart and
Gray wire must be connected to a ground source (
loop must be cut (
Rev A
b.
Do
NOT
connect the 2-pin harness (on SmartStart). Power and ground will be provided by
the
DBALL
D2D connector.
Connect SmartStart to
DBALL
OR
XL202 Installation
Connect
XL
202 to
DBALL
using the D2D port.
Connect the 10-pin
1
DBALL, then w
ait until the
Important: Do
NOT
Press
the ush-to-Start button once
P
The LED
turns
ON solid green for 3 seconds, then shuts
2
OFF.
Note: If the bypass was skipped, the LED flashes orange
then turns ON solid orange for 3 seconds and shuts off.
3
Press
the ush-to-Start button
P
successfully programmed.
You have successfully completed the module programming sequence.
(RSR)
s 11- 2
1 for more information and for troubleshooting purposes.
XL
202 or SmartStart module to
VIP
(version 4. or higher). Visit www.directechs.com to download the latest
model
of the vehicle; the page will refresh to display the compatible firmware.
Config for RSR
, and follow the instructions provided on the screen.
FLASH
be disconnected from any power source before SmartStart can
DBALL
Rev B
SmartStart).
using the D2D port.
, 1
2-pin
and 14-pin
harnesses to
LED
turns
ON
solid red
press the brake pedal.
to turn ignition ON.
once
to turn ignition O
Installation
DBALL
, it is important to ensure that the proper feature and
5
VIP
4.5 or higher. Using version 2.9 or 3.1 will limit
XKLoader
.
right
corner of the page.
button to upload the firmware onto the interface module.
.
DBALL
works properly, the
SmartStart), and the Brown or Blue
.
st
1
ENGINE
1X
START
STOP
FF once the module is
SmartStart
XL202
rd
3
nd
2
Do NOT
press the
brake pedal
&
PUSH
Solid
x 3 sec.
ENGINE
1X
START
STOP
© 2017 Directed. All rights reserved.
Rev.: 20
1707
12
Page 8
&
Solid
&
Off
PUSH
페이지 인쇄