AFSA 1258 매뉴얼 - 페이지 7

{카테고리_이름} AFSA 1258에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AFSA 1258 9 페이지. Water powered fruit press

Tel. +46 142 60 21 20

Webbutik: www.afsa.nu

Remove wing nut (9), cylinder lid (8), & steel cylinder (7). Place fabric mesh inside cylinder

with generous overlap top & bottom and re-fit cylinder (fig 3).

Fill press with the chopped apples (fig 4), place top of mesh over apple pulp. Re-fit cylinder lid

and hand tighten the wing nut. Place plastic cover over cylinder lid & cylinder. Ensure to have

a receptacle to catch the pressed juice. Close outlet valve, & open (unscrew) top vent.

Turn on supply to hose, then open the inlet valve, when water exits the top vent close the vent

(finger tight). The pressure on the gauge will rise to your water pressure. When the maximum

amount of juice has been extracted, the flow of juice will stop & water will flow from the

overflow valve underneath the press (red cap).

Close the inlet valve and open the outlet valve (SAFETY - leave outlet valve open until ready

to press next batch), once the water has drained, remove the plastic cylinder cover, wing nut,

lift the cylinder lid and empty the apple pulp. Refill with pulp, refit cylinder lid & wing nut,

close outlet valve and repeat operation.

At end of session ensure inlet valve closed and hose supply isolated, then open outlet valve

and drain system, remove inlet quick release fitting. Remove plastic cylinder cover, wing nut,

cylinder lid, empty pulp, remove fabric mesh, & cylinder. Open vent screw & inlet valve and

tilt base in direction of valves to finish draining, close both valves & vent screw.

Clean all surfaces, if using a pressure washer care must be taken not to damage the

rubber bladder. Dry the unit and store in a cool dry place out of direct sunlight to avoid

UV damage to the rubber bladder.

NEVER pressurize the bladder without fruit pulp, mesh fabric, secured lid, & cylinder

in place.

Fabric mesh can be cleaned in the washing machine at a max temperature of 30°

without detergent.

NEVER place a pressure washer nozzle within 2 feet (600mm) of the rubber bladder

when cleaning