Clarke 07097A 운영자 매뉴얼 - 페이지 10

{카테고리_이름} Clarke 07097A에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 07097A 20 페이지. 7" spinner edger ce
Clarke 07097A에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

MAINTENANCE

CAUTION:

Maintenance and repairs performed by

unauthorized personnel could result

in damage or injury. Maintenance

and repairs performed by unauthor-

ized personnel will void your warranty.

Servicing of these units must always be

referred to an authorized Clarke Ameri-

can Sanders distributor.

Remove the dust from the bag when the bag is

full or when the efﬁ ciency of the dust control system

decreases.

If the exhaust pipe gets an obstruction, follow this proce-

dure:

1. Remove the four screws that hold the exhaust

pipe to the housing. See ﬁ gure 5.

2. Remove the obstruction from the exhaust pipe.

3. Install the exhaust pipe.

How to Adjust the Angle Of The Sandpaper Disc To

The Floor

The adjustment of the machine is correct when the front

part of the sandpaper disc makes contact with the ﬂ oor.

To change the adjustment of the machine, follow

this procedure:

1. Using the special wrench, loosen the lock nut on

each caster. See (1) ﬁ gure 6.1.

2. Loosen the jam nut. See (2) ﬁ gure 6.2.

3. Raise or lower the casters as needed.

4. Tighten the jam nut on each caster.

5. Tighten the lock nut on each caster.

The Ventilation Plug

1. To clean the ventilation opening in the center of

the plug, remove the plug from the machine. With

the plug removed, also inspect the grease in the

gearbox. See ﬁ gure 7.

- 10 - FORM NO. 70162B

American Sanders B-2 (CE) Operator's Manual

Clarke

Figure 5

Figure 6

Figure 7