Clarke 07128A 운영자 매뉴얼 - 페이지 3

{카테고리_이름} Clarke 07128A에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 07128A 20 페이지. American b-2+ dc 7" edger
Clarke 07128A에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

페이지 인쇄

OPERATOR SAFETY INSTRUCTIONS

WARNING

DANGER means:

WARNING means:

CAUTION means:

DANGER:

Failure to read the Operator's Manual before operating or servicing this sanding equipment

could result in injury to the operator or to bystanders and could cause damage to the

equipment. Read and observe all safety statements found in this manual and on the

sanding equipment. Make sure all labels, decals, warnings, cautions and instructions are

fastened to the equipment. Replace any that are damaged or missing. You must have

training in the operation of this equipment before using it. If the operator is unable to

read this manual, have it explained fully before they attempt to use this equip-

ment.

DANGER:

Sanding/finishing wood floors can create an environment that can be explosive. The

following safety procedures must be adhered to:

• Cigarette lighters, pilot lights and any other source of ignition can create an explosion

when active during a sanding session. All sources of ignition should be extinguished or

removed entirely if possible from the work area.

• Work areas that are poorly ventilated can create an explosive environment when certain

combustible materials are in the atmosphere, i.e., solvents, thinners, alcohol, fuels,

certain finishes, wood dust and other combustible materials. Floor sanding equipment

can cause flammable material and vapors to burn. Read the manufacturer's label on all

chemicals used to determine combustibility. Keep the work area well ventilated.

• Spontaneous combustion or an explosion can occur when working with sanding dust.

The sanding dust can self-ignite and cause injury or damage. Sanding dust should be

disposed of properly. Always empty the sanding dust into a metal container that is

located outside of any building(s).

• Remove the contents of the dust bag when the bag is 1/3 full. Remove the contents of

the dust bag each time you finish using the equipment. Never leave a dust bag unat-

tended with sanding dust in it.

• Do not empty the contents of the dust bag into a fire.

• Hitting a nail while sanding can cause sparks and create an explosion or fire. Always

use a hammer and punch to countersink all nails before sanding floors.

Clarke American Sanders American B-2 Operator's Manual

AVERTISSEMENT

Severe bodily injury or death can occur to you or other personnel if the DAN-

GER statements found on this machine or in this Operator's Manual are

ignored or are not adhered to. Read and observe all DANGER statements

found in this Operator's Manual and on your machine.

Injury can occur to you or to other personnel if the WARNING statements

found on your machine or in this Operator's Manual are ignored or are not

adhered to. Read and observe all WARNING statements found in this

Operator's Manual and on your machine.

Damage can occur to the machine or to other property if the CAUTION state-

ments found on your machine or in this Operator's Manual are ignored or are

not adhered to. Read and observe all CAUTION statements found in this

Operator's Manual and on your machine.

ADVERTENCIA

Page 3