Clarke 3052025 운영 및 유지보수 지침 매뉴얼 - 페이지 4

{카테고리_이름} Clarke 3052025에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3052025 8 페이지. Polishing kit

SETUP

FITTING THE POLISHING WHEEL TO THE BENCH GRINDER

1. Remove the wheel and all guards from the left hand side of your bench

grinder.

• Consult the bench grinder user manual for instruction of how to do this.

• The inner guards are normally held on with 3 or 4 screws.

• When you revert the bench grinder back to normal use, ALL GUARDS

MUST BE REFITTED.

2. Slide the tapered shaft over the

spindle as shown.

• If you cannot slide it on easily,

you may need to loosen the

grub screws on either side of

the tapered shaft.

3. Use a small flat screwdriver to

tighten up grub screws on either

side of the tapered shaft.

4. Whilst holding the tapered shaft

with one hand screw the polishing

wheel onto the sharp end of the

tapered shaft by hand.

5. To remove the Polishing wheel,

simply screw the polishing wheel

in the opposite direction whist

holding the tapered shaft with

your other hand.

BUFFING WHEEL.

The buffing wheel is fitted in the same way as above.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]