Clarke 3110434 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke 3110434에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3110434 16 페이지. Orbital sander

AIR SUPPLY REQUIREMENTS

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE THOROUGHLY FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE

USE OF COMPRESSORS AND COMPRESSED AIR SUPPLY.

• Use only clean, dry, regulated compressed air as a power source.

• Air compressors used with the sander must comply with the appropriate

European Community safety directives.

• A build up of moisture in the air compressor will accelerate wear and

corrosion in the sander. Ensure any moisture is drained from the

compressor daily and the inlet filter is kept clean.

• If an unusually long air hose is required,(over 8 metres), line presure may

need to be increased.

• Never exceed the maximum operating pressure for the tool.

A typical airline arrangement is shown on the below. If an automatic in-

line filter/regulator/lubricator unit is used it will keep the tool in good

condition but should be regularly checked and topped up with oil.

IMPORTANT: If a filter/lubricator unit is not used, the sander should be

lubricated with 2 to 6 drops of oil, at least once a day or after 2 hours work,

depending upon the working environment. The oil can be inserted through

the airline connection point.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]