Clarke 3110650 운영 및 유지 관리 지침 - 페이지 10

{카테고리_이름} Clarke 3110650에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3110650 17 페이지.

MAINTENANCE

WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE

AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES.

DAILY

1. Before use, drain water from the air tank, air line and compressor.

2. Pour a few drops of CLARKE airline oil, into the air inlet. This should be

carried out regardless of whether or not an in-line mini oiler is used. If an in-

line mini oiler is not used, this procedure should be repeated after every

two to three hours of use.

WEEKLY

1. Wash the bonnets after each use by hand and use mild soap with water.

Hang them up to dry.

• Store them flat and allow them to regain shape.

2. Check the air inlet strainer for

blockage and clean if necessary.

CLEANING

1. Keep the body of the tool clean

and free from debris.

2. Grit or gum deposits inside the tool

may also reduce its efficiency. This

condition can be corrected by

cleaning out the air strainer and

flushing out the tool with gum solvent or oil, or failing this, the motor may

require dismantling. This is better left to your Clarke dealer.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]