Clarke 6462013 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke 6462013에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6462013 17 페이지. Oscillating bobbin sander

SETUP

1. Put the support washer on the

spindle.

• Grooved side must face up.

2. Slide the bobbin on to the spindle.

3. Secure the bobbin using the

correct washer, and nut supplied.

• Use the largest washer that

does not overlap the edge of

the sanding sleeve.

4. Do not tighten the nut fully yet.

5. Put the correct table insert into

place as shown and tighten up

the nut on top of the bobbin.

• The table insert must be used at

all times

• If the table insert is damaged It

must be replaced before use.

Spare parts are available from

the Clarke spare parts

department.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]