Clarke 6462021 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke 6462021에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6462021 11 페이지.
Clarke 6462021에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (13 페이지)

Operation

Fitting Sanding Pad.

a) Select pad to be used. (MUST be correct pads with velcro fitting ability).

b) Ensure sander is switched OFF and plug is removed from socket.

c) Line up holes in pad with those on machine pad. (this is necessary for dust

extraction), press pad firmly onto machine pad to secure it.

Dust Collection.

The dust collection bag/suction, (not supplied), is fitted to sander duct on sander

handgrip, below the mains cable.

Note :

If using a dust bag, it must be emptied regularly, do not wait until it is completely full.

To operate, plug into the mains supply then switch ON by sliding the switch, on top of the

unit, backwards. A speed selector wheel mounted behind the ON/OFF switch, allows the

sander to operate at speeds appropriate for the job in hand.

Offer sander to workpiece and work slowly backwards and forwards across the area to be

sanded until finished. Remove sander from workpiece and slide switch forwards to switch

OFF, (Wait until machine has stopped completely before putting it down.

Always inspect the tool before use, and ensure it is in top condition.

Ensure all air vents are clear, (use compressed air to clean the machine where possible).

Check the power cable to ensure it is sound and free from cracks, bare wires etc. avoid

using solvents when cleaning plastic parts, most plastics are susceptible to damage from

the various types of commercial solvents.

All bearings etc., in this tool are lubricated with a sufficient amount of high grade lubricant

for the tools lifetime under normal operating conditions, therefore no further lubrication is

required.

Trouble Shooting

Sander is overheating

This indicates the machine is dirty. Clean the ventilation holes, and blow out with compressed

air or clean with a dry cloth.

Overloading the machine will also cause overheating. Do not use for heavy duty work, and

do not apply excessive pressure.

Excessive sparking occurs

This indicates worn brushes. This problem is quickly remedied but you should consult your

CLARKE dealer for parts and advice.

Sander does not operate when switched ON

Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or the blows

-6-