Clarke 6462080 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke 6462080에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6462080 17 페이지.

ADJUSTING THE BELT TRACKING

WARNING: ALWAYS WEAR EYE PROTECTION WHEN ADJSUTING OR

OPERATING THE SANDER.

Having changed the belt, it is

important to make sure that the belt

runs square on the rollers. This is

achieved by adjusting the tracking.

TO ADJUST THE TRACKING, PROCEED

AS FOLLOWS:

1. Switch on the belt sander.

2. Adjust the tracking screw until the

sanding belt is running in line with

the flat side of the tool.

3. Turn the screw anti-clockwise to

run the belt into the tool. Turn the

screw clockwise to run the belt

away from the tool.

FITTING THE DUST COLLECTION BAG

When using the belt sander, certain materials will generate harmful or toxic

dusts and grit. For this reason it is important to fit the dust collection bag. Do

not allow the dustbag to get too full. Empty the bag before it becomes

overloaded.

1. Put the plastic nozzle of the dust

collection bag over the dust

extraction outlet.

2. Push firmly home.

3. To empty the dust bag, grasp the

bag by the plastic nozzle and pull

away from the dust extraction

outlet.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]