Clarke Air CAT176 운영 및 유지 관리 지침 - 페이지 11

{카테고리_이름} Clarke Air CAT176에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Air CAT176 17 페이지. Multi-sander kit

DISCONNECTING THE AIR SUPPLY

1. Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air released.

2. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

3. Once the pressure has been released, disconnect the air supply hose from

the air tool.

WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE

AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES.

DAILY

1. Before use, drain water from the air tank, air line and compressor.

2. Pour a few drops of CLARKE airline oil into the air inlet. This should be carried

out regardless of whether or not an in-line mini oiler is used. If an in-line

lubricator is not used, this procedure should be repeated after every two to

three hours of use.

WEEKLY

1. Check the air inlet strainer for

blockage and clean if necessary.

CLEANING

1. Keep the body of each tool clean

and free from debris.

2. Grit or gum deposits inside the tool

may also reduce its efficiency. This

condition can be corrected by

cleaning out the air strainer and

flushing out the tool with gum solvent or oil, or failing this, the motor may

require dismantling. This is better left to your Clarke dealer.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]