Clarke American Sanders Super 7R 운영자 매뉴얼 - 페이지 9
{카테고리_이름} Clarke American Sanders Super 7R에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke American Sanders Super 7R 16 페이지. Dc edger
Clarke American Sanders Super 7R에 대해서도 마찬가지입니다: 운영자 매뉴얼 (17 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Operator Safety Instructions
- 3. Machine Specifications
- 4. Sanding Cuts and Sandpaper
- 5. Machine Set-Up
- 6. Operating Instructions
- 7. Adjustment Procedures
- 8. Routine Maintenance
- 9. Maintenance
- 10. Parts and Service Manual - Section II Assembly Drawing
- 11. Assembly Parts List
- 12. Wiring Diagram 11/04
ADJUSTMENT PROCEDURES
Leveling
To level machine: Grasp caster adjusting screw "A" with an
appropriate tool (pliers ect.). Using a similar tool, loosen
locknut "B" with a counter clockwise motion. (Figure 4).
Condition - Pad creates ridges on both edges or a "hop" is
experienced: Rotate both adjusting screws equal amounts
clockwise. Tighten locknuts and test on a piece of ply-
wood. Repeat procedure until condition is corrected. We
recommend you not exceed 1/8" rotation for each attempt.
Condition - Pad creates a ridge on the tip of the pad:
Rotate both adjusting screws counter clockwise, tighten
locknuts and test. Repeat procedure until condition is
corrected. Use only 1/8 rotation for each attempt.
Condition - Pad creates a ridge on only one side of the pad:
Either rotate the adjusting screw of the side effected
clockwise or rotate theadjusting screw opposite counter-
clockwise, depending on whether the ridge terminates
beyond the tip of the pad or prior to it. If it is prior to the
tip, adjust the side effected, otherwise adjust the opposite
side.
ROUTINE MAINTENANCE
CAUTION: Failure to perform maintenance at
recommended intervals may void
warranty.
Carbon Brushes
Have the carbon brushes replaced at least every 500
hours and more frequently under heavy use.
Dust Bag
Periodically the dust bag should be turned inside out,
shaken vigorously and machine washed in cold water
to prevent pore blockage and loss of dust control.
Bearings
To insure reliable performance, have armature and pad
driver bearings inspected for wear or damage after every
1500 hours. If used heavily, have the bearings replaced
seasonally.
Lubrication
The machine comes fully lubricated. The gears in the
gear box have enough lubrication for approximately six
months of normal operation. Have the lubricant changed
at least every 6 months or more frequently under heavy
use.
®
Clarke
American Sanders Super 7R Operator's Manual
A
B
Figure 4
Page 9