Clarke CAT111 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke CAT111에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT111 16 페이지. Orbital sander

AIR SUPPLY REQUIREMENTS

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE THOROUGHLY FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE

USE OF COMPRESSORS AND COMPRESSED AIR SUPPLY.

• Air compressors used with the sander must comply with the appropriate

European Community safety directives.

• Use only clean, dry, regulated compressed air as a power source for the

sander.

• A build up of moisture in the air compressor will accelerate wear and

corrosion in the sander. Ensure any moisture is drained from the

compressor daily and the inlet filter is kept clean.

• If an unusually long air hose is required,(over 8 metres), line presure may

need to be increased.

A typical airline

arrangement is

shown on the right.

If an automatic in-

line filter/regulator/

lubricator unit is

used it will keep the

tool in good

condition but should

be regularly

checked and

topped up with oil.

IMPORTANT: If a filter/lubricator unit is not used, the sander should be

lubricated with 2 to 6 drops of oil, at least once a day or after 2 hours work,

depending upon the working environment. The oil can be inserted through

the airline connection point.

AIRLINE SAFETY

• Never exceed the maximum operating pressure for the sander. A pressure

of 90 psi with a flow of 6 cfm is required. Too high an air pressure will

shorten the life of the tool due to excessive wear.

• The air hose must be rated at least 150% of the maximum operating

pressure of the tool.