Clarke CAT70 운영 및 유지보수 지침 매뉴얼 - 페이지 2

{카테고리_이름} Clarke CAT70에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT70 7 페이지. Heavy duty belt sander
Clarke CAT70에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (17 페이지)

페이지 인쇄

SPECIFICATIONS

Model: ................................................................. CAT 70

Part No: ................................................................ 3110750

Belt Speed: .......................................................... 1500 M/Min

Maximum Air Consumption: ............................. 17 CFM

Standard Belt Size ............................................... 20mm x 520mm

Recommende Air Pressure ................................ 90 PSI (6.2bar)

Air Inlet Size ......................................................... 1/4" BSP

Minimum Hose Size ............................................. 5/16" (8mm)

Overall Length .................................................... 345mm

Weight ................................................................. 1.2 kg

Noise Level .......................................................... 90 dB(A)

Please note that the details and specifications contained herein are correct at the time of going to

print. However CLARKE International reserve the right to change specifications at any time without

prior notice. Always consult the machines data plate

Employers are advised to refer to the HSE publication "Guide for Employers".

All hand held power tools vibrate to some extent, and this vibration is transmitted to the operator via the handle, or hand used

to steady the tool. Vibration from about 2 to 1500 herz is potentially damaging and is most hazardous in the range from about

5 to 20 herz.

Operators who are regularly exposed to vibration may suffer from Hand Arm Vibration Syndrome (HAVS), which includes

'dead hand', 'dead finger', and 'white finger'. These are painful conditions and are widespread in industries where vibrating

tools are used.

The health risk depends upon the vibration level and the length of time of exposure to it......in effect, a daily vibration dose.

Tools are tested using specialised equipment, to approximate the vibration level generated under normal, acceptable operating

conditions for the tool in question. For example, a grinder used at 45° on mild steel plate, or a sander on softwood in a

horizontal plane etc.

These tests produce a value'a', expressed in metres per second per second, which represents the average vibration level of

all tests taken, in three axes where necessary, and a second figure 'K', which represents the uncertainty factor, i.e. a value in

excess of 'a', to which the tool could vibrate under normal conditions. These values appear in the specification panel below.

For an explanation of Hand-Arm Vibration, please see page 7

MODEL No:

DESCRIPTION:

Declared vibration emmission value in accordance with

Measured vibration emmission value - a:

Uncertainty value - K:

Highest measured reading in a single plane

Values determined according to EN28622-1

HAND-ARM VIBRATION

CAT70

20mm BELT SANDER

EN12096

- 1 -

<2.5m/s

m/s

0.39m/s