Clarke CAT80 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke CAT80에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT80 16 페이지. 6” dual-action sander

INSTALLING THE DISC

1. To assemble the pad to the tool,

turn the locking nut (A) until the

knurled portion contacts the flat

surface on the output spindle (B).

2. Thread the pad into the spindle

by gripping theorbital hub (C)

with one hand and the pad with

the other.

3. Turn the locking nut until the

spindle turns freely. Do Not

operate the tool with the spindle

in the locked mode as performance would be severly affected and a

hazardous situation could result.

CONNECTING THE AIR SUPPLY

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF

COMPRESSORS AND COMPRESSED AIR SUPPLIES.

Note: Ensure the compressor is turned off.

1. Remove the plastic blanking plug

from the connection port of the

tool as shown.

2. Pour 2-3 drops of CLARKE airline

oil into the air inlet. This should be

done regardless of whether or not

a lubricated air supply is to be

used.

3. Connect a suitable hose to the

tool as shown.

4. Connect the other end of the

hose to the compressor. (A whip hose with a quick fit coupling is available

from your CLARKE dealer).

5. Turn on the air supply and check for air leaks. Rectify any found before

proceding. The tool is now ready for use.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]