Aleko AR2000 사용자 설명서 - 페이지 7

{카테고리_이름} Aleko AR2000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko AR2000 16 페이지.

AR2000 SLIDING GATE OPERATOR

Magnets for limit switch

Install the magnet as shown in Fig.7 and Fig.8 below. The magnet and limit switch are used to

control the position of the gate.

When the magnet is installed, release the gear clutch and push the sliding gate manually to

pre-determine the position. Fit the magnet bracket to the rack and then tighten the gear clutch.

The lower bracket is for open position and higher bracket is for close position. Fix the magnet to

the bracket. Finally adjust the magnet to the proper position by moving the gate with the motor.

The magnet should be 10~15mm away from the magnetic limit switch. If it is too far away, the

switch will fail to work. Adjust the position of the magnetic limit switch until the positions of the

opening and closing meet the requirement.

Fig.6

Fig.7