Clarke CDS1V 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke CDS1V에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CDS1V 13 페이지.
Clarke CDS1V에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (11 페이지)

3. Regularly check the condition of the sanding pad and replace when

necessary.

4. On very uneven surfaces or when removing layers of paint, start with a

coarse grit. On other surfaces, start with a medium grit. In both cases,

gradually change to a fine grit for a smooth finish.

5. Always use a sanding sheet that is in top condition;- damaged backing will

cause damage to the base plate. Please note that base plates are NOT

covered by the warranty.

6. Always place the sander on the workpiece before switching ON. This will

prevent the edge of the moving sander from making a scar on the

workpiece.

7. Move the sander evenly and smoothly over the surface of the workpiece

with only light pressure. This helps to produce an even finish and will also

prolong the life of the sanding sheet.

8. Let the sander do the work. Ensure the sander is flat on the work surface

and DO NOT apply excess pressure as this will not only produce an uneven

finish but will overload the motor causing it to burn out.

9. Wait until the sander has stopped completely before putting it down.

10. If the sander is not removing material efficiently, check the sanding sheet. If

the abrasive is worn down replace the sheet. The sanding sheet must

always be stored in a dry place as if it allowed to become damp, the

abrasive particles will detach from the backing sheet and will not abrade.

MAINTENANCE

Your sander will operate over a long period of time with a minimum of

maintenance. Continuous satisfactory operation depends upon proper care.

There are no user-serviceable parts in this sander. The bearings in this sander

are sealed for life and require no maintenance.

Regularly clean the ventilation slots using a soft dry brush or dry cloth. Do not

use any abrasive or solvent-based cleaner.

A damaged power cable should be replaced by your CLARKE dealer or

qualified electrician.

Overloading the sander will also cause overheating. Do not use for heavy duty

work and do not apply excess pressure.

Excessive sparking indicates worn brushes. This problem is quickly remedied

but you should consult your CLARKE dealer for parts and advice.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]