Aleko LOCKMASTER L110C 매뉴얼 - 페이지 8

{카테고리_이름} Aleko LOCKMASTER L110C에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko LOCKMASTER L110C 17 페이지.

페이지 인쇄

ALEKO AC-2000 SLIDING GATE OPERATOR

Driven sprocket bracket

Fix the driven sprocket bracket on both sides of the operator.

Operator

In locations where ground freeze is possible, mount the gate operator as shown in Fig.5

installation 1 or installation 2. Check the operator and make sure it is lined up with the gate.

Chain Brackets

Use the appropriate bolts to attach the chain bracket to the frame of the gate. If the gate is of

square frame style, use the square bolts shown.

Plain washer ( Φ 6)

Spring washer ( Φ 6)

Master link

If the gate is of round frame style, use the round bolts shown.

Plain washer ( Ф 6

Spring washer ( Ф 6)

Master link

Chain

Close the gate and attach a chain bolt to the chain using enclosure master links. Tighten the

chain bolt to the bracket with washers and nuts. Pull the chain through the sprockets to the

other chain bracket at the opposite end of the gate see Fig.9. Connect the other end of the

chain and the chain bolt, and then tighten the chain bolt to the chain bracket. Thread up the

chain by adjusting the chain bolt. Cut the chain to length if necessary. Tighten the chain by

tightening the chain bolts at either end. See Fig.8.

Gate

Nut (M6)

Chain bolt

Gate

)

Nut (M6)

Chain bolt

Chain

Square frame

Square bolt

"L" bracket

Plain washer ( Φ 8)

Spring washer ( Φ 8)

Nut (M8)

Fig.6

Round frame

Round bolt

"L" bracket

Plain washer ( Ф 8)

Spring washer ( Ф 8)

Nut (M8)

Fig.7

Master link

Fig.8