Clarke Contractor CBS2 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke Contractor CBS2에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Contractor CBS2 17 페이지.
Clarke Contractor CBS2에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (17 페이지)

페이지 인쇄
Clarke Contractor CBS2 운영 및 유지보수 지침 매뉴얼
• On very uneven surfaces or when removing layers of paint, start with a
coarse grit. On other surfaces, start with a medium grit. In both cases,
gradually change to a fine grit for a smooth finish.

MAINTENANCE

WARNING: MAKE SURE THAT THE BELT SANDER IS SWITCHED OFF AND
DISCONNECTED FROM THE MAINS SUPPLY BEFORE STARTING ANY
CLEANING OR MAINTENANCE PROCEDURES.
After use clean out any accumulated dust etc. Keep the cooling vents clear. If
the sander should become too hot, run it for 2 minutes without load.
Clean the housing with a soft cloth. Any worn or damaged parts should be
replaced by qualified personnel. Keep the handles clean and free from oil
and grease. Refer to qualified service personnel if internal maintenance is
required.
Always store the belt sander in the carrying case.

CHANGING THE CARBON BRUSHES

1. With a suitable screwdriver, remove the carbon brush caps on either side of
the belt sander.
2. Remove the carbon brush/spring assembly.
3. If the carbon brushes are worn down to 4mm, or less, replace them with
the new brushes (1 spare set supplied).
4. Replace the carbon brush caps and tighten them.
NOTE: Both brushes must be replaced at the same time.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10