Clarke Contractor CON180 운영 및 유지 관리 지침 - 페이지 11
{카테고리_이름} Clarke Contractor CON180에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Contractor CON180 16 페이지.
페이지 인쇄
FAULTFINDING
Problem
Tool will not operate
Motor runs but pad
does not rotate
Heavy internal sparking
Motor becomes hot
Excessive vibration
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Possible Cause
No power supply.
Faulty switch.
Fuse blown.
Faulty motor.
Pad fastening not
engaged.
Drive gear broken.
Faulty motor.
Unduly heavy use.
Air vents have
become blocked.
Low supply voltage.
Disc not mounted
correctly.
Machine bearings
worn.
11
Remedy
Check supply and rectify
as necessary.
Consult your Clarke dealer
Consult your Clarke dealer
if necessary.
Consult your Clarke dealer
Press drive lock button
and tighten pad.
Consult your Clarke dealer
Consult your Clarke dealer
Reduce the force applied
to the tool. Let the tool do
the work.
Clean out the air vents
using compressed air or
clean with a dry cloth.
Ensure supply voltage is
correct. If an extension
cable is used, ensure it is of
the correct rating and is
fully unwound.
Check and rectify.
Consult your Clarke dealer