Clarke CONTRACTOR CON320 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke CONTRACTOR CON320에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR CON320 13 페이지. Orbital sander

MAINTENANCE

WARNING: BEFORE PERFORMING ANY MAINTENANCE, SWITCH OFF AND

UNPLUG THE SANDER.

Your sander will operate over a long period of time with a minimum of

maintenance. Continuous satisfactory operation depends upon proper care.

Regularly clean the motor ventilation slots using a soft dry brush or dry cloth to

remove dust. Do not use any abrasive or solvent-based cleaner.

A damaged power cable should be replaced by your CLARKE dealer or

qualified electrician.

There are no user-serviceable parts in this sander. The bearings in this sander

are sealed for life and require no maintenance.

FAULTFINDING

SANDER IS OVERHEATING

This indicates the machine is dirty. Clean the ventilation holes, and blow out

with compressed air. Always wear eye protection when using compressed air.

Overloading the machine will also cause overheating. Do not use for heavy

duty work, and do not apply excessive pressure.

EXCESSIVE SPARKING OCCURS

This indicates worn brushes. This problem is quickly remedied but you should

consult your CLARKE dealer for parts and advice.

SANDER DOES NOT OPERATE WHEN SWITCHED ON

Check to ensure the fuse is sound and replace if necessary. If the fuse is sound

or blows repeatedly, consult your CLARKE dealer.

POOR ABRASION

If the sander is not removing material efficiently, check the sanding sheet. If

the abrasive is worn down replace the sheet. The paper must always be stored

in a dry place as if it allowed to become damp, the abrasive particles will

detach from the sheet and will not abrade.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]