Aleko HTIO2BLD 조립 설명서 - 페이지 11

{카테고리_이름} Aleko HTIO2BLD에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko HTIO2BLD 14 페이지. Inflatable spa
Aleko HTIO2BLD에 대해서도 마찬가지입니다: 조립 설명서 (14 페이지)

MAINTENANCE

4. Cleaning the Spa

Detergent residues and dissolved solids from bathing suits and chemicals will gradually accumulate in the spa's water.

To clean the spa, use soap and water then rinse.

Note: Do not use hard brushes or abrasive cleaners.

EMPTY, DEFLATE AND STORAGE

1. Empty

Remove the Spa plug from the electrical mains.

2) Unscrew cap from Water Outlet below air inlet valve of Spa. Ensure the Drainage Plug (See the " Part f " picture) is still

inserted to prevent unexpected draining.

3) Screw Inflation Hose (See the "Part c" picture) onto the Water Outlet and direct open the end of inflation hose

appropriately.

4) Remove the Drainage Plug (Part f ) from the floor of the Spa, so water can flow out (Fig.5).

5) Once drained use a sponge to absorb excess water, then you MUST operate air jet function for at least 30 seconds to

drain the water from the air pipeline.

6) When draining is finished, remove the Inflation Hose (Part c) and replace the Drainage Plug (Part f ) and water outletcap.

2. Deflate

1) Find the black 1-way valve on the Spa (See the Fig.3)

2) Fully unscrew and remove rapid deflation air valve by turning anti-clockwise to allow the air to escape.

3) Fold away the Spa carefully directly and removing as much air as possible through the open valve.

3. Spa Storage

• Make sure all water is drained from the spa and pump system. This is essential to extend the life of the spa.

We recommend the use of a wet/dry vacuum to blow out or suck up water from the spa pipes and pump lines.

• Remove the filter cartridge.

• It is recommended you store the spa in its original package in a warm dry place.

Note: Plastic becomes brittle and susceptible to breakage when exposed to subzero temperatures. Freezing can

severely damage the spa. Improper winterization of your spa may void your warranty.

Fig. 5