Aleko B6C Series 사용자 설명서 - 페이지 4

{카테고리_이름} Aleko B6C Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko B6C Series 16 페이지. Outdoor barrel sauna with/without canopy

Tools :

Ⅰ. Base Assembly

(1)

Placement of base

Place the base shown in the figure, and adjust it in horizon by pads

(beneath the base).

(2)Bottom stave assembly

①

Take out the stave with drain hole and cable hole in the middle of the base, place

other stave in the same level with this one, and fix the end to the base with screws.

Note: Use stave with preset screw holes.

Firstly it must be fasten the stave to the base by screws at two ends.

W h e n u s i n g t h e p l a s t i c f e e t ,

no need to use the pad under the base

With Canopy

Without Canopy

(mm)

200

150

200

150

200

150

200

150

200

150

①

Insert other stave to the edge of the base, gently tap them with a rubber hammer to

make them tightly packed and check to ensure the distance of front and back bases

from the edge of stave is 150mm. (shown in Figure 2

②

Ensure all cross slots are aligned and apply glass glue. (shown in Figure 2

③ Use screws to fasten the inserted staves onto the base. All the screws should be with

countersink processing. (Figure 2 ④)

③

warning: this step must be used after step4. Steel Strip Assembly.

②)

Center line

- 4 -

③)

Figure 2