California Air Tools 365 매뉴얼 - 페이지 6

{카테고리_이름} California Air Tools 365에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. California Air Tools 365 9 페이지. 5 gallon pressure pot with hvlp spray gun and hose

페이지 인쇄

Trouble Shooting

WARNING:

If any of the following symptoms appears during your operating, stop using the tool immediately, or

serious personal injury could result.

Only a qualified persons or an authorized service center can perform repairs or replacement of tool.

Disconnect tool from air supply before attempting repair or adjustment. When replacing O-rings or

Cylinder, lubricate with air tool oil before assembly.

PROBLEMS

Air escaping from port on

regulator cap

Pressure dropping slowly

on gauge.

Fluid or air leak at the lid

gasket.

Paint in tank tends to

settle rapidly.

Gauge not registering air

pressure.

Safety valve popping off.

Note: Repairs should be carried out by a qualified person.

POSSIBLE CAUSES

Broken or damaged

diaphragm in regulator.

Dirty or work valve seat in

regulator.

Defective lid gasket.

Thumb screw not tight.

Paint not mixed or thinned

properly.

Defective air gauge.

Tank pressure to high.

Defective valve.

CORRECTION

Replace regulator

Replace lid gasket.

Tighten thumb screws.

Mix or thin paint according to instruction on

paint.

Replace air gauge

Reduce tank pressure to 20-50 PSI.

Replace safety valve.