Clarke JETSTAR 1600 운영 및 유지보수 매뉴얼 - 페이지 5

{카테고리_이름} Clarke JETSTAR 1600에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke JETSTAR 1600 9 페이지. Powerwasher

페이지 인쇄

1. Parts Lists and Diagrams

Jet 3000

Part Nos. for Jet 3000 are the same as those for Jetstar 1600, except for item 5,

which has 3 components shown below, the Hex wrench, plus additional

components:

No. Description

LP Water Inlet Adapter Ring

LP Water Inlet Adapter Gasket

LP Water Inlet Adapter Hose Holder

Hex. Wrench (for turning motor)

Wheel

Axle

Axle Clamps

Part No.

FP52037300

FP52037400

FP52037500

FP15609900

FP17807000

FP52436400

FP50148700

ELECTRICAL CONNECTIONS

WARNING: THIS MACHINE MUST BE EARTHED.

This product is provided with a standard 13 amp, 230 volt (50Hz), BS 1363 plug, for

connection to a standard, domestic electrical supply.

Should the plug need changing at any time, ensure that a plug of identical

specification is used. IMPORTANT: The wires in the mains lead should be wired up

in accordance with the following colour code:

Green & Yellow ............................. Earth

Blue ................................................ Neutral

Brown ............................................. Live

As the colours of the wires in the mains lead may not correspond with the coloured

markings identifying the terminals in your plug, proceed as follows:

•

Connect GREEN & YELLOW coloured cord to plug terminal marked with a

etter "E" or Earth symbol "

•

Connect BROWN coloured cord to plug terminal marked letter "L"

•

Connect BLUE coloured cord to plug terminal marked letter "N"

We recommend that this machine is connected to the mains supply through a

Residual Current Device (RCD).

FUSE RATING

The fuse in the plug for this appliance must be ASTA approved to BS1362. AND

rated at 13 amps

IMPORTANT:

If this appliance is fitted with a plug which is moulded onto the electric cable (i.e.

non-rewirable) :

The plug must be thrown away if it is cut from the electric cable. There is a

danger of electric shock if it is subsequently inserted into a socket outlet.

Never use the plug without the fuse cover fitted.

Should you wish to replace a detachable fuse carrier, ensure that the correct

replacement is used (as indicated by marking or colour code).

Replacement fuse covers can be obtained from your local dealer or most

electrical stockists.

EXTENSION CABLES

If an extension cable is used, always ensure it is fully unwound. When used

outdoors, ensure the extension cable is specifically designed for outdoor use.

The maximum extension length is 25 metres. Ensure that the wire sizes in the cable

is at least 0.75mm

in cross section. As a general rule, the extension cable must be

thicker than the cable supplied with the washer.

IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

Do not attempt any electrical repairs yourself.