Clarke METALWORKER CBB250 운영 및 유지보수 지침 매뉴얼 - 페이지 5
{카테고리_이름} Clarke METALWORKER CBB250에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke METALWORKER CBB250 13 페이지. 250mm buffer/polisher
페이지 인쇄
2. DO NOT switch the buffer/polisher on whilst the mop is in contact with the
workpiece.
3. Avoid polishing dissimilar metals with the same buffing mop; galvanic
corrosion may occur.
4. DO NOT touch the workpiece immediately after polishing as it may be hot.
5. DO NOT touch the buffing mop whilst operating or whilst plugged into the
mains power.
6. DO NOT leave the buffer/polisher running unattended.
7. When not in use, switch the buffer/polisher off and unplug from the power
supply.
SAFETY SYMBOLS
SAFETY SYMBOLS & PICTOGRAMS
The following safety symbols are found on the product
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Read the manual
and safety
instructions before
use
Ear protection
should be worn
Hazard;- motor gets
hot
5
Eye protection
should be worn
Dust mask should be
worn
Wear protective
gloves