Clarke PS105 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke PS105에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke PS105 8 페이지.

Operation

Fitting Sanding Pad.

a) Select pad to be used. (MUST be correct pads with velcro fitting ability).

b) Ensure sander is switched OFF and plug is removed from socket.

c) Line up holes in pad with those on machine pad. (this is necessary for dust

extraction), press pad firmly onto machine pad to secure it.

Dust Extraction.

Dust extraction equipment (not supplied) , can be used with your sander, this is possible by

connecting a suitable hose to the outlet port at the rear of the machine just below the

power supply cable entry.

Using The Sander.

Holding the sander firmly, insert the plug into the mains socket and switch ON, turn the

sander on by operating the switch on the front of the tool.

Offer sander to workpiece and work slowly backwards and forwards across the area to be

sanded until finished. Remove sander from workpiece and switch OFF. Wait until machine

has stopped completely before putting it down.

Note: Do Not start the sander whilst it is in contact with the workpiece.

Always inspect the tool before use, and ensure it is in top condition.

Ensure all air vents are clear, (use compressed air to clean the machine where possible).

Check the power cable to ensure it is sound and free from cracks, bare wires etc. Avoid

using solvents when cleaning plastic parts, most plastics are susceptible to damage from

the various types of commercial solvents.

All bearings etc., in this tool are lubricated with a sufficient amount of high grade lubricant

for the tools lifetime under normal operating conditions, therefore no further lubrication is

required.

Trouble Shooting

Sander is overheating

This indicates the machine is dirty. Clean the ventilation holes, and blow out with compressed

air or clean with a dry cloth.

Overloading the machine will also cause overheating. Do not use for heavy duty work, and

do not apply excessive pressure.

Excessive sparking occurs

This indicates worn brushes. This problem is quickly remedied but you should consult your

CLARKE dealer for parts and advice.

Sander does not operate when switched ON

Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or blows

repeatedly, consult your CLARKE dealer.

-5-