Clarke Woodworker BS1 운영 및 유지보수 지침 매뉴얼 - 페이지 7
{카테고리_이름} Clarke Woodworker BS1에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Woodworker BS1 13 페이지. Belt sander
Clarke Woodworker BS1에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (4 페이지)
페이지 인쇄
PREPARATION
CAUTION: DISCONNECT THE PLUG FROM THE POWER SUPPLY BEFORE
CHANGING THE BELT.
CHANGING THE SANDING BELT
With the mains cable disconnected from the mains supply, select the abrasive
belt appropriate for the job in hand and attach it to the machine as follows:
1. Pull out the belt tension lever fully,
in the manner shown.
• This will allow the belt to be
slipped over the front and rear
rollers.
2. Centralise the belt, then gently
release the tensioning
lever...under control...do not allow
it to spring back.
ADJUSTING THE BELT TRACKING
WARNING: ALWAYS WEAR EYE PROTECTION WHEN ADJUSTING OR
OPERATING THE SANDER.
It is essential that the belt runs true
between the rollers otherwise it will
have the tendency to run off.
A tracking adjuster is provided as
indicated. Turn the adjuster so that
the front roller appears to be square,
then switch on the sander.
Observe the belt and turn the
adjuster knob clockwise or
anticlockwise to ensure the belt runs
truly.
Once satisfied, the sander is ready for use.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7