Directed Electronics 140HF 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Directed Electronics 140HF에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 140HF 18 페이지.

To perform Valet Take-Over:

Before turning off the engine, press and release

on the transmitter (or press and release the optional Momen-

tary switch).

Turn the ignition key to the OFF position.

(The engine will stay running.)

The engine will run until the pre-programmed time elapses or

a shut-down input is received. (See the previous Remote Start

section for a complete list of shut-down inputs.)

NOTE: This feature will not work if the brake pedal is being pressed.

Using Remote Start with Factory Remote Systems

This remote start system is also designed to interface with most

original equipment from manufacturer (OEM) factory remote sys-

tems. The Remote Start/Valet Take-Over sequence can be pro-

grammed to initiate with one to three (1-3) presses of one of the

OEM transmitter buttons. Consult with your dealer to determine

the transmitter button and the number of presses (1-3) that have

been programmed for this sequence. Spaces are provided below for

writing in the button and number of button presses.

OEM transmitter button used for Remote Start/Valet Take-Over

sequence____________________________________________

Number of presses required to initiate Remote Start/Valet

Take-Over sequence___________________________________

and

1999 Directed Electronics, Inc.