Clarke X-Pro CAT136 운영 및 유지 관리 지침 - 페이지 8

{카테고리_이름} Clarke X-Pro CAT136에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke X-Pro CAT136 17 페이지. Dual action air sander

available from your CLARKE dealer. Replace the screw before using

the tool.

4. If a mini-oiler is not being used, run a few drops of oil through the tool

before use. It can be entered through the inlet strainer or via the hose at

the nearest connection to the air supply.

5. Connect the other end of the hose to the compressor.

6. Turn on the air supply and check for air leaks. Rectify any found before

proceeding. PTFE tape may be useful for sealing threaded connections.

7. Your air tool is now ready for use.

• You can fit a whip hose with a quick fit coupling if required

(available from your Clarke dealer.)

OPERATING

ADJUSTING THE SPEED

1. Squeeze the trigger against the

body of the tool to start the

sander and control the speed.

Evaluate the speed and adjust as

follows.

2. Adjust the operating speed by

twisting the speed control shown.

• The speed of rotation is shown

by the arrow embossed on the

tool body (anti-clockwise will

increase the sanding speed.)

3. To begin work, rest the disc pad on the workpiece and start the sander.

• Let the tool do the work. The actual weight of the machine is

normally sufficient for efficient sanding. Do not put additional

pressure on the machine, which would only slow down the speed of

the pad, reducing efficiency and placing an additional burden on

the motor.

4. Pass the sander back and forth in wide, overlapping areas, taking care to

keep the sander moving around at all times. Avoid dwelling in one place

for more than a moment.

5. Release the trigger to stop the tool.

6. Always ensure the tool has stopped before putting it down.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]