Clarke X-PRO CAT165 운영 및 유지 관리 지침 - 페이지 9

{카테고리_이름} Clarke X-PRO CAT165에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke X-PRO CAT165 17 페이지. 10mm air belt sander

• Let the tool do the work. The actual weight of the sander is normally

sufficient for efficient sanding. Do not put additional pressure on the

sander, which would only slow down the speed of the belt, reducing

efficiency and placing an additional burden on the motor.

4. Take care to keep the sander moving around at all times. Avoid dwelling in

one place for more than a moment.

5. When finished sanding, release the throttle lever and allow the motor to

stop before carefully putting the tool down.

DISCONNECTING THE AIR SUPPLY

1. Do not disconnect the air supply hose until the air supply has been shut

down and the compressed air released.

2. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

3. Once the pressure has been released, disconnect the air supply hose from

the sander.

WARNING: MAKE SURE THAT THE SANDER IS DISCONNECTED FROM THE

AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE

PROCEDURES.

Please note that factors other than the tools condition may effect its operation

and efficiency, such as reduced compressor output, excessive drain on the

airline, moisture or restrictions in the airline, or the use of connectors of

improper size or poor condition which will reduce the air supply.

DAILY

1. Before use, drain water from the airline and compressor.

2. Lubricate the air tool daily for optimum performance. Use a high quality

airline oil either via a lubricator in the air supply system or by placing a few

drops into the air inlet immediately before use. This should be carried out

regardless of whether or not an in-line lubricator is used.

CLEANING & OVERHAUL

1. Keep the moving parts clean and free from debris.

2. If the sander becomes sluggish and the air supply is of good quality, it may

be necessary to replace worn or damaged parts.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]